Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 838

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-FIX
FXS-TM20 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TMP-TB23 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FXS-TM24 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Set ITOP control temp: plain, 1/2 SPD
To set the offset of ITOP control temperature for plain paper 1 to 3, recycled paper 1 to 3, thin
paper 1/2, colored paper, tracing paper, pre-punched paper and bond paper at 1/2 speed.
As the value is changed by 1, the control temperature is changed by 5 deg C.
Decrease the value when uneven gloss occurs, and increase the value when a fixing failure occurs
on the leading edge of paper.
When uneven gloss occurs on the leading edge (76 mm) of plain paper, etc. at 1/2 speed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, uneven gloss may occur.
If the value is too small, a fixing failure may occur on the leading edge of paper. (Toner does not
peel off.)
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set fixing control temp: plain, 1/2 SPD
To set the offset of fixing control temperature for plain paper 1 to 3, recycled paper 1 to 3, thin
paper 1/2, colored paper, tracing paper, pre-punched paper and bond paper at 1/2 speed.
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
When a fixing failure/fixing offset occurs on plain paper, etc. at 1/2 speed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set ITOP control temp: thin paper 2
To set the offset of ITOP control temperature for thin paper 2 (52 to 59 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Decrease the value when uneven gloss occurs, and increase the value when a fixing failure occurs
on the leading edge of paper.
- When a fixing failure occurs on the leading edge of paper
- When uneven gloss occurs on the leading edge (74 mm)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, uneven gloss may occur.
If the value is too small, a fixing failure may occur on the leading edge of paper. (Toner does not
peel off.)
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
816
8. Service Mode