6. Pull out the next upper cassette, and check that the Adjustment Plate is correctly pushed against the frame.
CAUTION:
• If the Adjustment Plate is not correctly pushed against the frame, image cannot be correctly adjusted.
• When checking with the Cassette 3, the cassette front cover must be removed.
7. Check that the margin is within the standard values.
■ Adjustment Procedure (service mode)
Adjust the service values on the following service mode.
1. <Leading Edge>
COPIER > ADJUST > FEED-ADJ > REGIST : 1/1 speed, front side
COPIER > ADJUST > FEED-ADJ > REG-DUP1 : 1/1 speed, back side
COPIER > ADJUST > FEED-ADJ > REG-THCK : 1/2 speed, front side
COPIER > ADJUST > FEED-ADJ > REG-DUP2 : 1/2 speed, back side
Leading edge margin is increased or decreased 0.1mm by 1 setting value.
2. <Left Edge>
COPIER > ADJUST > FEED-ADJ > ADJ-C1/C2/C3/C4/MF : front side
COPIER > ADJUST > FEED-ADJ > ADJ-C1RE/C2RE/C3RE/C4RE/MFRE : back side
Left edge margin is increased or decreased 0.1mm by 1 setting value.
3. When the service setting values is adjusted, write the replaced service setting values on the service label .
Reference: Standard value
Leading edge: 4.0+1.5/-1.0mm(front side, back side)
Left edge: 2.5±1.5mm(front side) / 2.5±2.0mm(back side)
Feeding direction
-
+
COPIER>ADJUST>FEED-ADJ
ADJ-xx/ADJ-xxRE
xx = C1/C2/C3/C4/MF
+
-
274
5. Adjustment