Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 626

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFCH-G2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
DFCH-G10 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
MTF2-M10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Complex chart No.2 data (G) entry: back
To derive the front/back side linearity, enter the Green data on the back side of No.2 image in
DADF complex chart.
Enter the value of service label on the Reader.
The setting of this item is enabled only when the DADF (1-path model) is installed.
When replacing the Main Controller PCB/clearing the Reader -related RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
1 to 2550
2000
1
Complex chart No.10 data (G) entry: back
To derive the front/back side linearity, enter the Green data on the back side of No.10 image in
DADF complex chart.
Enter the value of service label on the Reader.
The setting of this item is enabled only when the DADF (1-path model) is installed.
When replacing the Main Controller PCB/clearing the Reader -related RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
0 to 2550
0
1
MTF value 10 entry:horz scan, front side
To enter the setting value 10 for calculating MTF filter coefficient in horizontal scanning direction
of the Scanner Unit (for front side).
Enter the value of service label on the Reader.
- When replacing the Scanner Unit
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
604
8. Service Mode