Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1060

Copy Card Reader-F1/Copy
Card Reader Attachment Kit-
B5
Points to Note at Installation
• To install this equipment, the Copy Card Reader
Attachment Kit is required.
• Refer to "Table of Options Combination" when installing
this equipment before operation.
• To install the Copy Card Reader, the Copy Card Reader
Attachment Kit is required.
Table of Options Combination
Utility Voice
Tray Opera-
tion Kit
Copy Yes Yes
Card
Reader
Yes: Available
No: Unavailable
CAUTION:
Marked portion
When tightening the screws, do not tighten them too
tightly. Otherwise, there is a risk of damage and
deformation of screw holes.
Voice Serial Copy
Guid- Inter- Control
ance Kit face Kit Inter-
face Kit
Yes No No
Essential Items to Be
Performed Before Installation
• Turn OFF the main power of the host machine, and
disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the
power plug of the host machine, it may cause
electrical shock.
• If disconnecting the power plug without
turning OFF the main power, it may cause
damage of the machine.
• When turning OFF the main power, follow the below
procedure.
1. Turn OFF the main power switch of the host
machine.
2. The display in the Control Panel and the lamp of the
main power are turned off.
Points to Note when turning
ON/OFF the main power
The following message is displayed.
1. When a message prompting to turn OFF and then ON
the main power appears, turn OFF and then ON the main
power switch.
2. If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host
machine is started. In the service mode ( Lv.2 ) shown
below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Installation Outline Drawing
1038
9. Installation