E613-0512-00 Faulty/Insufficient Image Memory; E613-1024-00 Faulty/Insufficient Image Memory; E613-1536-00 Faulty/Insufficient Image Memory; E613-2048-00 Memory Error - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E613-0512-00
Detection Description
Remedy
E613-1024-00
Detection Description
Remedy
E613-1536-00
Detection Description
Remedy
E613-2048-00
Detection Description
Remedy
E614-0001-00
Detection Description
Remedy
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
[Related parts] Main Controller PCB (UN05)
[Remedy] Check/replace the Main Controller PCB.
[Reference] Before replacing the Main Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
[Related parts] Main Controller PCB (UN05)
[Remedy] Check/replace the Main Controller PCB.
[Reference] Before replacing the Main Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Faulty/insufficient image memory
No necessary memory at Main Controller PCB
[Related parts] Main Controller PCB (UN05)
[Remedy] Check/replace the Main Controller PCB.
[Reference] Before replacing the Main Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Memory error
Memory of the Main Controller PCB is faulty.
[Related parts] Main Controller PCB (UN05)
[Remedy] Check/replace the Main Controller PCB.
[Reference] Before replacing the Main Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Flash PCB error
The Flash PCB could not be recognized, or the Flash PCB was not formatted.
[Related parts]
- Flash PCB
- Main Controller PCB (UN05)
[Remedy] Perform the following in the order while checking whether the error is cleared.
Reinstall the necessary application software once the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB to check that it is
installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
3. Replace the Main Controller PCB.
[Reference] For backup and restoration, refer to "Adjustment> Main Controller System" and
"Appendix> Backup Data List" in the Service Manual.
Before replacing the Main Controller PCB, back up the service mode data (approx. 2 min) and
restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
434
7. Error/Jam/Alarm