Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 716

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > HV-TR
TR-VL10 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
TR-VL11 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
Sec trn indiv set ppr allot voltg:set 10
To adjust the paper allotted voltage of secondary transfer for setting 10.
Setting 10 is the combination condition of environment, paper type (paper weight), color mode/
feed side that are set in TR-ENV10, TR-PPR10 and TR-DUP10. When this condition is satisfied,
the paper allotted voltage adjusted here is applied at the time of secondary transfer. If the setting
of 2TR-OFF is made, the setting voltage is added to the paper allotted voltage.
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
As the value is changed by 1, the voltage is changed by 30 V.
+: Increase
-: Decrease
When an image failure occurs on all paper types (mottled image, density loss due to excessive
transfer, toner scattering on solid image, etc.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 at a time while checking the symptom.
-128 to 127
V
-30 - 30
0
COPIER> ADJUST> HV-TR> TR-ENV10, TR-PPR10, TR-DUP10, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
30
Sec trn indiv set ppr allot voltg:set 11
To adjust the paper allotted voltage of secondary transfer for setting 11.
Setting 11 is the combination condition of environment, paper type (paper weight), color mode/
feed side that are set in TR-ENV11, TR-PPR11 and TR-DUP11. When this condition is satisfied,
the paper allotted voltage adjusted here is applied at the time of secondary transfer. If the setting
of 2TR-OFF is made, the setting voltage is added to the paper allotted voltage.
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
As the value is changed by 1, the voltage is changed by 30 V.
+: Increase
-: Decrease
When an image failure occurs on all paper types (mottled image, density loss due to excessive
transfer, toner scattering on solid image, etc.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 at a time while checking the symptom.
-128 to 127
V
-30 - 30
0
COPIER> ADJUST> HV-TR> TR-ENV11, TR-PPR11, TR-DUP11, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
30
694
8. Service Mode