Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 997

010: Line connection identification time
Set the line connection identification time.
Increase this parameter in the case of frequent errors caused by line connection status at the time of communication.
NOTE:
Error codes caused by line connection status
##005, ##018
The line connection identification time is the duration from when the dial signal is transmitted until the line is disconnected at the
sending side, or from when DIS signal is transmitted until the line is disconnected at the reception side.
011: T.30 T1 timer (for reception)
Set T1 timer at the time of reception (wait time until receiving the meaningful signal after DIS transmission).
013: T.30 EOL timer
Set the receivable 1 line transmission time.
In the case of a long line data length (e.g.: computer FAX), extend the transmission time to prevent reception errors.
015: Hooking detection time
Set the hooking detection time.
016: Time until the primary response is obtained when switching FAX/TEL
Set the time from when capturing the line until transmission of pseudo RBT at FAX/TEL switching function operation.
017: Pseudo RBT signal pattern ON time/ 018: Pseudo RBT signal pattern OFF time (short)/ 019: Pseudo
RBT signal pattern OFF time (long)
Set the pattern of pseudo RBT signal to be sent at Fax/Tel switching function operation.
020: Pseudo CI signal pattern ON time/ 021: Pseudo CI signal pattern OFF time (short)/ 022: Pseudo CI
signal pattern OFF time (long)
Set the pattern of pseudo CI signal to be sent at Fax/Tel switching function operation.
023: CNG detection level when switching FAX/TEL
Set the CNG detection level at Fax/Tel switching function operation.
024: Pseudo RBT transmission level when switching FAX/TEL
Set the transmission level of pseudo RBT at Fax/Tel switching function operation.
025: CNG monitoring time when the answering phone connection function is set
027: V21 low-speed flag preamble detection time
Set the period of time for judge detection of V.21 low-speed command preamble.
Continuous detection for the fixed period of time leads to command analysis.
028: Off-hook PCB duty settings
Set the Off-hook PCB duty setting.
When 0 or a value that is 100 or more is entered, the duty becomes 50%.
080: Transmission number restriction: Outside line transmission number
This sets the number permitted to dial to the outside line.
Only the outside line transmission by the set number is permitted and other numbers are prohibited from transmission.
Setting of Destination (TYPE)
■ Overview
When the type shown on the display is set, all the service data is set to match each country domestic telecommunication standards.
975
8. Service Mode