Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 665

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > COLOR
ADJ-M 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ADJ-C 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ADJ-K 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
OFST-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Adjustment of color balance for M-color
To adjust the default value of the color balance for M-color when the density of M-color varies
between devices.
As the value is larger, the image gets darker. If the value is too large, a transfer failure and/or a
fixing failure occurs.
Upon user's request (to reduce density difference between devices)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Adjustment of color balance for C-color
To adjust the default value of the color balance for C-color when the density of C-color varies
between devices.
As the value is larger, the image gets darker. If the value is too large, a transfer failure and/or a
fixing failure occurs.
Upon user's request (to reduce density difference between devices)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Adjustment of color balance for Bk-color
To adjust the default value of the color balance for Bk-color when the density of Bk-color varies
between devices.
As the value is larger, the image gets darker. If the value is too large, a transfer failure and/or a
fixing failure occurs.
Upon user's request (to reduce density difference between devices)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-8 to 8
0
Adj Y-clr brit area dens&color balance
To adjust the bright area density and color balance of Y-color.
As the value is larger, the image gets darker.
Decrease the value when the background cannot be read correctly because the density of a
document is dark and increase the value when the density of a document is light.
Decrease the value when removal of the background is not performed correctly and a fogging-like
image appears.
This setting is linked with [Correct Density], [Correct Shading] and [Auto Correct Color Mismatch]
in [Settings/Registration].
- When the background of a document cannot be read correctly
- When removal of the background cannot be performed correctly and a fogging-like image appears
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-32 to 32
0
643
8. Service Mode