Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 593

COPIER (Service mode for printer) > DISPLAY (State display mode) > DENS
DENS-S-C 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
DENS-S-K 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
D-Y-TRGT 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
D-M-TRGT 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
D-C-TRGT 2
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
SGNL-Y 1
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
Related Service Mode
SGNL-M 1
Detail
Use Case
Display/Adj/Set Range
Appropriate Target Value
Related Service Mode
Dspl ATR control C-color patch density
To display C-color patch image density formed at ATR control.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 1023
100 - 600
Dspl ATR control Bk-color patch density
To display Bk-color patch image density formed at ATR control.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 1023
100 - 600
Dspl Y-clr patch target dens: ATR ctrl
To display the target density for Y-color patch image formed at ATR control.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 1023
150 - 500
Dspl M-clr patch target dens: ATR ctrl
To display the target density for M-color patch image formed at ATR control.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 1023
150 - 500
Dspl C-clr patch target dens: ATR ctrl
To display the target density for C-color patch image formed at ATR control.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 1023
150 - 500
Display of Y-color toner density
To display the measured value of Y-color toner density.
The density is measured with the ATR Sensor (Y) for each job.
The value is updated upon print operation after power-on.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 255
50 - 200
COPIER> DISPLAY> DENS> DENS-Y
Display of M-color toner density
To display the measured value of M-color toner density.
The density is measured with the ATR Sensor (M) for each job.
The value is updated upon print operation after power-on.
When analyzing the cause of image failure (fogging, carrier adherence, low density, etc.)
0 to 255
50 - 200
COPIER> DISPLAY> DENS> DENS-M
571
8. Service Mode