Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 636

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > IMG-REG
REG-H-M 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
REG-V-M 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
REG-HS-M 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
MAG-H 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Ruf adj M-clr wrt start pstn:horz scan
To adjust the write start position of M-color image in the horizontal scanning direction in increments
of 1 pixel.
When M-color displacement in horizontal scanning direction occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
It is recommended to use this item from situation mode.
-128 to 127
pixel
0
1
Ruf adj M-clr wrt start pstn:vert scan
To adjust the write start position of M-color image in the vertical scanning direction in increments
of 1 pixel.
When M-color displacement in vertical scanning direction occurs
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
It is recommended to use this item from situation mode.
-128 to 127
line
0
1
Fine adj M-clr wrt start pstn:horz scan
To adjust the write start position of M-color image in the horizontal scanning direction in increments
of less than 1 pixel.
When M-color displacement in horizontal scanning direction occurs (smaller than 1 pixel)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
It is recommended to use this item from situation mode.
-128 to 127
pixel
0
1/16
Adj of stdrd magnifictn ratio: horz scan
To adjust the standard magnification ratio in the horizontal scanning direction by increasing/
decreasing the number of pixels.
As the value is changed by 1, the magnification ratio is changed by 0.1%.
The adjustment result is reflected to all colors.
All correction values registered in the media list are proportionally changed.
When adjusting the standard magnification ratio due to parts replacement or environmental
change, etc.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-10 to 10
%
0
0.1
614
8. Service Mode