Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 616

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
100DF2GB 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
100DF2RG 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
DFCH2R2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
Img Sensr GB color displace crrct: back
To correct the color displacement between G and B lines in vertical scanning direction due to the
Scanner Unit (for back side).
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of service label.
The setting of this item is enabled only when the DADF (1-path model) is installed.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-256 to 256
line
0
0.001
Img Sensr RG color displace crrct: back
To correct the color displacement between R and G lines in vertical scanning direction due to the
Scanner Unit (for back side).
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of service label.
The setting of this item is enabled only when the DADF (1-path model) is installed.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-256 to 256
line
0
0.001
Complex chart No.2 data (R) entry: front
To derive the front/back side linearity, enter the Red data on the front side of No.2 image in DADF
complex chart.
Enter the value of service label on the Reader.
The setting of this item is enabled only when the DADF (1-path model) is installed.
When replacing the Main Controller PCB/clearing the Reader -related RAM data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
1 to 2550
2000
1
594
8. Service Mode