E5F0-8001-02 Error In The Saddle Paper End Stopper Motor (Finisher-Aa1); E5F0-8002-02 Error In The Saddle Paper End Stopper Motor (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E5F0-8001-02
Detection Description
Remedy
E5F0-8002-02
Detection Description
Remedy
Error in the Saddle Paper End Stopper Motor (Finisher-AA1)
The saddle paper end stopper does not come off the Saddle Paper End Stopper HP Sensor when
the Saddle Paper End Stopper Motor has been driven for 1 second.
STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses from the Saddle Paper End Stopper HP Sensor (PS210) to the Saddle Stitcher
Controller PCB
- Harnesses from the Saddle Paper End Stopper Motor (M206) to the Saddle Stitcher Controller
PCB
- Saddle Paper End Stopper HP Sensor (PS210)
- Saddle Paper End Stopper Motor (M206)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Saddle Paper End Stopper Motor (Finisher-AA1)
The Saddle Paper End Stopper HP Sensor does not detect the saddle paper end stopper when
the Saddle Paper End Stopper Motor has been driven for 4 seconds.
STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses from the Saddle Paper End Stopper HP Sensor (PS210) to the Saddle Stitcher
Controller PCB
- Harnesses from the Saddle Paper End Stopper Motor (M206) to the Saddle Stitcher Controller
PCB
- Saddle Paper End Stopper HP Sensor (PS210)
- Saddle Paper End Stopper Motor (M206)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
409
7. Error/Jam/Alarm