Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 955

FEEDER (ADF service mode) > FUNCTION (Operation / inspection mode)
MTR-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
ROLL-CLN 1
Detail
Use Case
Adj/Set/Operate Method
FEED-ON 1
Detail
Use Case
Adj/Set/Operate Method
Related Service Mode
OPTION (Specification setting mode)
FEEDER (ADF service mode) > OPTION (Specification setting mode)
R-ATM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
R-OVLPLV 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Operation check of DADF motor
To start operation check for the motor specified by MTR-CHK.
At operation check
1) Select the item, and then press OK key.
The unit operates for approximately 5 seconds and automatically stops.
2) Press OK key.
The operation check is completed.
Be sure to press the OK key again after execution. The operation automatically stops after
approximately 5 seconds, but is not completed unless the OK key is pressed (STOP is not
displayed).
FEEDER> FUNCTION> MTR-CHK
Rotation of DADF rollers
To rotate the rollers of DADF for cleaning.
Check the rollers with lint-free paper moistened with alcohol while they are rotating.
When cleaning the rollers
1) Select the item, and then press OK key.
2) Clean the rotating rollers with lint-free paper moistened with alcohol.
3) Press OK key.
The rollers stop.
Operation check of DADF individual feed
To start operation check of the feed mode specified by FEED-CHK.
At operation check
Select the item, and then press OK key.
FEEDER> FUNCTION> FEED-CHK
Set DADF dble fd dtct H-land mode:1-path
To set the Double Feed Sensor of the DADF (1-path model) to the highland mode.
Set 1 if the installation site is above the altitude of 2000 meters.
When the installation site is above the altitude of 2000 meters at installation
Enter the setting value, and then press OK key.
0 to 1
0: Normal, 1: Highland mode
0
Set DADF dble fd dtct thrshld VL: 1-path
To set the threshold value at which the Double Feed Sensor of the DADF (1-path model) judges
whether papers are double fed.
Decrease the value if single feed of paper is incorrectly detected as double feed.
Increase the value if double feed of paper is incorrectly detected as single feed.
When double feed is incorrectly detected with special paper not defined in the specifications
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
In the case of highlands, be sure to set R-ATM in advance.
-3 to 3
0
FEEDER> OPTION> R-ATM
933
8. Service Mode