Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 794

COPIER (Service mode for printer) > OPTION (Specification setting mode) > NETWORK
WUEN-LIV
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
IFX-CHIG
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
DNSTRANS
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
2 Recovery time setting after sleep notice
To set the time from the sleep start from network without job assignment until the mode is shifted
to the sleep mode.
When setting the startup time after sleep notification
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
10 to 600
sec
15
1
1 Set operation by IFAX recv mail content
To set the number of characters for the IFAX received mail content, so that the mail is not printed/
forwarded when the characters in the text is less than the number of specified characters.
This machine can output blank paper because some senders send e-mail text consists of linefeed
codes only. In such case, specify 2 (number of characters) so that there will be no output of blank
paper.
In the case of specifying any number other than 0, header/footer is printed/forwarded in 1 sheet
only if the e-mail (body) text is less than the specified value while no TIFF file is attached.
As the value is incremented by 1, the number of target characters in e-mail body text is increased
by 1 character.
When reducing print of blank paper due to e-mail received by IFAX
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to get approval from the user by telling that there will be no print of e-mail (body) text if
the number of characters is less than the specified value.
0 to 999
0: E-mail (body) text is not ignored.
char
0
1 Japanese Kanji character is calculated as 2 bytes, and the control codes (such as linefeed code,
etc) are included in the number of characters.
1 Setting of DNS query priority protocol
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set priority of the protocol (IPv4/IPv6) for DNS query.
In the case of using both IPv6 and IPv4 while the DNS server supports IPv4, it takes time because
of timeout when executing DNS query with priority on IPv6. Giving priority on query by IPv4 can
shorten the time.
When it takes time to execute DNS query with priority on IPv6 because the DNS server supports
IPv4
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: IPv4, 1: IPv6
1
772
8. Service Mode