Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 842

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-FIX
TMP-TB28 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TMP-TB29 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
EXTH-LP 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
Set fixing control temp: coated paper 4
To set the offset of fixing control temperature for coated paper 4 (221 to 256 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
When a fixing failure/fixing offset occurs on coated paper 4
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, fixing offset may occur.
If the value is too small, a fixing failure may occur.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set fixing control temp: coated paper 5
To set the offset of fixing control temperature for coated paper 5 (257 to 300 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
When a fixing failure/fixing offset occurs on coated paper 5
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, fixing offset may occur.
If the value is too small, a fixing failure may occur.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set fix arch control: heavy ppr/coat ppr
To set the arch amount between secondary transfer and fixing when feeding heavy paper 7 and
coated paper 4/5.
Increase the value when shock image occurs at the trailing edge of heavy paper or coated paper.
The arch amount is decreased so that shock can be alleviated.
When shock image occurs at the area around 60 mm or 130 mm from the trailing edge of heavy
paper or coated paper
Enter the setting value, and then press OK key.
Change the value by 1 at a time while checking the symptom. If the value is increased too much
at a time, image at the trailing edge may disturb.
0 to 4
0: Maximum, 1: Large, 2: Medium, 3: Small, 4: Minimum
0
15mm
820
8. Service Mode