Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 840

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-FIX
FXS-TM28 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FXS-TM29 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TMP-TB24 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Set ITOP control temp: coated paper 4
To set the offset of ITOP control temperature for coated paper 4 (221 to 256 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Decrease the value when uneven gloss occurs, and increase the value when a fixing failure occurs
on the leading edge of paper.
- When a fixing failure occurs on the leading edge of paper
- When uneven gloss occurs on the leading edge (74 mm)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, uneven gloss may occur.
If the value is too small, a fixing failure may occur on the leading edge of paper. (Toner does not
peel off.)
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set ITOP control temp: coated paper 5
To set the offset of ITOP control temperature for coated paper 5 (257 to 300 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Decrease the value when uneven gloss occurs, and increase the value when a fixing failure occurs
on the leading edge of paper.
- When a fixing failure occurs on the leading edge of paper
- When uneven gloss occurs on the leading edge (74 mm)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, uneven gloss may occur.
If the value is too small, a fixing failure may occur on the leading edge of paper. (Toner does not
peel off.)
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
Set fixing control temp: thin ppr 2
To set the offset of fixing control temperature for thin paper 2 (52 to 59 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
When a fixing failure/fixing offset occurs on thin paper 2
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If the value is too large, fixing offset may occur.
If the value is too small, a fixing failure may occur.
-2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
deg C
0
5
818
8. Service Mode