Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 712

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > HV-TR
TR-VL2 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
TR-VL3 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
Sec trns indiv set ppr allot voltg:set 2
To adjust the paper allotted voltage of secondary transfer for setting 2.
Setting 2 is the combination condition of environment, paper type (paper weight), color mode/feed
side that are set in TR-ENV2, TR-PPR2 and TR-DUP2. When this condition is satisfied, the paper
allotted voltage adjusted here is applied at the time of secondary transfer. If the setting of 2TR-
OFF is made, the setting voltage is added to the paper allotted voltage.
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
As the value is changed by 1, the voltage is changed by 30 V.
+: Increase
-: Decrease
When an image failure occurs on all paper types (mottled image, density loss due to excessive
transfer, toner scattering on solid image, etc.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 at a time while checking the symptom.
-128 to 127
V
-30 - 30
0
COPIER> ADJUST> HV-TR> TR-ENV2, TR-PPR2, TR-DUP2, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
30
Sec trns indiv set ppr allot voltg:set 3
To adjust the paper allotted voltage of secondary transfer for setting 3.
Setting 3 is the combination condition of environment, paper type (paper weight), color mode/feed
side that are set in TR-ENV3, TR-PPR3 and TR-DUP3. When this condition is satisfied, the paper
allotted voltage adjusted here is applied at the time of secondary transfer. If the setting of 2TR-
OFF is made, the setting voltage is added to the paper allotted voltage.
Increase the value when low-voltage mottled image or toner scattering on solid image occurs.
Decrease the value when high-voltage mottled image or density loss due to excessive transfer
occurs.
As the value is changed by 1, the voltage is changed by 30 V.
+: Increase
-: Decrease
When an image failure occurs on all paper types (mottled image, density loss due to excessive
transfer, toner scattering on solid image, etc.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Increase/decrease the value by 1 at a time while checking the symptom.
-128 to 127
V
-30 - 30
0
COPIER> ADJUST> HV-TR> TR-ENV3, TR-PPR3, TR-DUP3, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
30
690
8. Service Mode