Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 152

NOTE:
The quick startup function can be set from "Settings/Registration".
• Settings/Registration > Preferences > Timer/Energy Settings > Quick Startup Settings for Main Power
[On]: Quick startup is executed (default)
[Off]: Quick startup is not executed
Disconnect the power plug when performing work with the possibility to come in contact with the PCBs above. If a conductive
material comes in contact with the PCB, short circuit may occur in the PCB, and may cause damage on it.
The following label is used at the place where attention is required.
Conditions for not executing quick startup
This machine does not execute quick startup if the following conditions are met at first startup after the power plug is connected
to the outlet.
Connection status of the hardware
• A coin vendor is connected.
Either of the following network settings is set to "ON":
Settings/Registration > Preferences > Network
• AppleTalk Settings > Use AppleTalk > ON
• Slect Wired/Wireless LAN > Wireless LAN
• Slect Wired/Wireless LAN > Wired LAN + Wireless LAN
• Bluetooth Settings > ON
When turning ON the main power of the machine after turning OFF the main power in any of the conditions below
• The system is running/communicating.
Others
• More than 110 hours have elapsed after quick startup
• When turning ON the main power of the machine in 20 seconds after turning OFF the main power
• Startup after 8 hours or more have passed since the power of this product was turned OFF
• When turning ON the main power of the machine after turning OFF the main power from the Remote UI
• The next time the power is turned ON after occurrence of the error code
• The next time the power is turned ON after shifting to the service mode screen
Quick Start
Plug Off
130
2. Technology