Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1071

Stamp Unit-B1
Points to Note at Installation
CAUTION:
Marked portion
When tightening the screws, do not tighten them too
tightly. Otherwise, there is a risk of damage and
deformation of screw holes.
Essential Items to Be
Performed Before Installation
• Turn OFF the main power of the host machine, and
disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the
power plug of the host machine, it may cause
electrical shock.
• If disconnecting the power plug without
turning OFF the main power, it may cause
damage of the machine.
• When turning OFF the main power, follow the below
procedure.
1. Turn OFF the main power switch of the host
machine.
2. The display in the Control Panel and the lamp of the
main power are turned off.
Points to Note when turning
ON/OFF the main power
The following message is displayed.
1. When a message prompting to turn OFF and then ON
the main power appears, turn OFF and then ON the main
power switch.
2. If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host
machine is started. In the service mode ( Lv.2 ) shown
below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Installation Outline Drawing
Checking the Contents
1x
*1: Used only for 1-path DADF.
< Others >
Including guides
Installation procedure
• Although pictures or illustrations used for
explanationmay differ from the actual things, the
procedure is the same.
NOTE:
Proceed to the appropriate procedure from this point on.
• In the case of 1-path ADF
Pass DADF" on page 1050
• In the case of Reverse ADF
Reversal DADF " on page 1053
1049
9. Installation
1
1x 1x
P Tightening
M3x12
1x
Binding
M3x6
1x
" In the case of the Single
" In the case of the