Communications Specifications Settings - Omron SYSMAC FH Series User Manual

2-5-4

Communications Specifications Settings

The communications settings must be set separately for Ethernet and RS-232C communications.
If communications cannot be performed even after setting these communications settings, check the
settings and the communications status.
For details, refer to 2-5-7 Testing Communications on page 2 - 338.
Precautions for Correct Use
• The settings dialog box for the communication specifications will change depending on the
Communication Module that you use.
Before you set the communication specifications, select the Communication Module to use
with the Sensor Controller in the startup settings.
For details, refer to 2-5-3 Communications Module Settings (Startup Settings) on page
2 - 317.
After you selected the Communication Module, save the settings to the Sensor Controller and
restart it.
If you do not restart the Sensor Controller, the selected Communication Module will not be
enabled.
• Use the same communication settings for the Sensor Controller and the external device.
• Do not input signals to Ethernet from an external device while setting the Ethernet system
settings.
• If the operation mode is set to Multi-line Random-trigger Mode, the Controller address cannot
be set for line 1 onward. (The same setting for line 0 is used.)
Connecting via Ethernet
1
On the Main window, click Tool - System Settings to open the system settings.
2
In the tree view on the left, select System Settings - Communication - Ethernet Normal
(xyz) ("xyz" depends on the Communication Module).
The Ethernet view is displayed.
3
Set each item.
• UDP case
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
2 Methods for Connecting and Communicating with External Devices
2
2 - 319