Omron SYSMAC FH Series User Manual page 512

Appendices
Support-
ed bit
Line 0
BIT5 0
BIT6 0
BIT7 0
BIT8 0
BIT9 0
BIT10 0
BIT11 0
BIT12 0
BIT13 0
BIT14 0
BIT15 0
FH-L series Sensor Controller
Terminal
Support-
ed bit
Line 0
BIT0 STEP0
BIT1 DSA0
BIT2 0
BIT3 0
BIT4 0
BIT5 0
BIT6 0
BIT7 0
BIT8 0
BIT9 0
BIT10 0
BIT11 0
BIT12 0
BIT13 0
BIT14 0
BIT15 0
Precautions for Correct Use
• When the Multi-line Random-trigger mode is selected in the following series, usable signal
type or assignment are differ depending on the used number of Lines.
• FH-1000 series
• FH-2000 series
• FH-3000 series
• FH-5000 series
For more details of Operation mode, refer to Multi-line Random-trigger Mode Signal Specifi-
cations on page 2 - 386.
• The terminal status of each line can be got by sending this command to the port number allo-
cated to them. For signals that are common in all lines, the terminal status can be got from
any line used.
When the terminal status for an unusable line or a different line was got, the response code
will be OK and the response data will always be 0.
Check the status of the received data by changing the actual parallel terminal status.
A - 40
Line 1 Line 2 Line 3
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
Terminal
Line 4 Line 5
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Line 6 Line 7
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0