Omron SYSMAC FH Series User Manual page 45

For communication settings

Hide thumbs Also See for SYSMAC FH Series:

Table of Contents

Settings Required for Data Output

Use the following procedures to set up Output Unit for data output.

● Measurement Data

(1) Place the data output processing unit(s) in the processing flow.

Place the processing unit for data output in the measurement flow.

Processing Units That Serve as Output Units:

On the processing item tree in the Flow Editor window, the processing items under Output result

serve as Output Units.

Output Unit Selection:

Select the Output Units with the following combination according to a communication protocol to

For details of communication protocols, refer to 1-3-4 Communication Protocols for Communicat-

ing with the Sensor Controller on page 1 - 9.

Result Output (I/O)

Result Output (Message)

Result Output (Parallel

Parallel Data Output

Parallel Judgment Output

Serial Data Output

Fieldbus Data Output

Except message communications

Precautions for Correct Use

When Non-procedure UDP is used to output data of Result output (Message), the Sensor Con-

troller outputs the data to only the device whose command was accepted in the end.

(2) Set the items to output

Set the items to output as output data in the Output Units placed in the measurement flow.

For the procedures to set output items in the Output Units, refer to the description for each com-

munication protocol.

FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)

OK: Data can be output, - : Data cannot be output.

Communication Protocol

Show Quick Links

Table of Contents

Troubleshooting