Communication Specifications Settings - Omron SYSMAC FH Series User Manual

2 Methods for Connecting and Communicating with External Devices
2-2-4

Communication Specifications Settings

Here, set the communication specifications such as the link areas, baud rate, and data length.
The communication settings are performed for Ethernet and RS-232C separately.
If communications were not established even though the settings have been performed, check the set-
ting details and communication status.
For details, refer to 2-2-7 Testing Communications on page 2 - 165.
Precautions for Correct Use
• The settings dialog box for the communication specifications will change depending on the
Communication Module that you use.
Before you set the communication specifications, select the Communication Module to use
with the Sensor Controller in the startup settings.
For details, refer to 2-2-3 Communications Module Settings (Startup Settings) on page
2 - 130.
After you selected the Communication Module, save the settings to the Sensor Controller and
restart it.
If you do not restart the Sensor Controller, the selected Communication Module will not be
enabled.
• Use the same communication settings for the Sensor Controller and the external device.
• Do not input signals to Ethernet from an external device while setting the Ethernet system
settings.
Connecting via Ethernet
1
On the Main window, click Tool - System Settings to open the system settings.
Select System Settings and then select Communication → Ethernet (PLC Link (SYSMAC
CS/CJ/CP/One)), Ethernet (PLC Link (MELSEC QnU/Q/QnAS)), or Ethernet (PLC Link
(JEPMC MP)).
The Ethernet view is displayed.
2
In the communication setting area, set each items.
In the case of Ethernet (PLC Link (SYSMAC CS/CJ/CP/One) (UDP)):
2 - 132
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)