Omron SYSMAC FH Series User Manual page 297

XFLG
XBUSY
XWAIT
ERR
GATE
Command Code
Response Code
Response Data
• Output area
Output data 1
Output data 8
l Specify the I/O memory addresses to access each communication area
By setting AT specifications to variables, assigned destination to each communication area can be
specified in the unit of the I/O memory address.
1
Setting the tag sets (by Network Configurator)
Directly specify the tag names in the PLC by using the I/O memory addresses that each com-
munication area is assigned to. (The output tags are specified for the input connections to the
Sensor Controller and the input tags are specified for the output connections to the PLC.)
Setting example
Output tag
Input tag
2
Setting Variables (by Sysmac Studio)
Define variables with AT (assigned destination) specifications to the I/O memory addresses as-
signed to each communication area as shown below.
Setting example
a
b
c
d
3
Setting Connections
Configure the connections as shown below.
Originator device (PLC) settings
Input tag set: D0
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
2 Methods for Connecting and Communicating with External Devices
Signal name
Signal name
.
.
.
Tag kind
Variable
Variable name
EIPInput.StatusFlag.F[8]
EIPInput.StatusFlag.F[9]
EIPInput.StatusFlag.F[10]
EIPInput.StatusFlag.F[15]
EIPInput.StatusFlag.F[16]
EIPInput.CommandCodeEcho
EIPInput.ResposeCode
EIPInput.ResposeData
Variable name
EIPInput.OutputData[0]
.
.
.
EIPInput.OutputData[7]
Assigned I/O memory address
D0
D100
AT specification
D0.0
D0.1
D0.15
D1.0
Target device (Sensor Controller) settings
Output tag set: Input101
2
2 - 235