Communication Specifications Settings - Omron SYSMAC FH Series User Manual

2 Methods for Connecting and Communicating with External Devices
2-4-6

Communication Specifications Settings

Set the output handshaking and output controls for communications.
Precautions for Correct Use
• Set the Communications Module to PROFINET in the startup settings before setting the com-
munications specifications.
For details, Refer to 2-4-5 Communications Module Settings (Startup Settings) on page
2 - 269
After you selected the Communication Module, save the settings to the Sensor Controller and
restart it.
If you do not restart the Sensor Controller, the selected Communication Module will not be
enabled.
Furthermore, if the operation mode is set to the Multi-line Random Trigger Mode, the Com-
munications Modules for lines 1 and higher must also be set to PROFINET.
• When using Multi-line Random-trigger Mode, specify different addresses for the sending and
receiving areas for each line.
Setting IP Address
Set the IP address for the Sensor Controller.
Precautions for Correct Use
Set the same IP address as it set by I/O controller such as a PLC. In PROFINET communica-
tions, an IP address set by I/O controller is prioritized.
1
On the Main window, click Tool - System Settings to open the system settings.
2
In the tree view on the left, select System Settings - Communication - Ethernet Normal
(xyz) ("xyz" depends on the Communication Module).
The Ethernet view is displayed.
3
Set each item.
• UDP case
2 - 270
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)