Omron SYSMAC FH Series User Manual page 609

<Command>
<Response>
PARAALLCOND or PAC
Gets all parallel terminal states at once, except for DI terminals
Gets the ON/OFF states of all parallel terminals at once, except for DI terminals.
For how to set, refer to the following contents or example.
Example:
When you want to get the parallel terminal state of Line 0 except DO to turn ON at once:
(1) Send this command to the port number set on Line 0.
(2) The parallel terminal state except DI is responded.
<Command format>
or
<Response format>
When processing is performed normally:
When processing is not performed normally:
<Parameters explanation>
Terminal state
*1: Assigned terminal to each bit
FH-1000/2000/3000/5000 series Sensor Controller
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
Terminal state
0: OFF
1: ON
For assigned terminal to each bit, refer to *1.
Appendices
A
A - 137