Controller Specifications - Omron FJ-3000-10 Instruction Manual

Controller Specifications

Operation
Serial communications
Network communications
EtherNet/IP communication
Parallel I/O
Monitor interface
USB interface
Power supply voltage
Current consumption
(At Power supply voltage
24 V DC)
Insulation resistance
Dielectric strength
Leakage current
Noise resistance
Vibration resistance
Shock resistance
Ambient temperature
range
Ambient humidity range
Ambient environment
Ground
Degree of protection
Environmental conditions
(according to
IEC61010-1)
Case materials
Weight
LCD integrated type: Touch pen, mouse etc.
BOX type: Mouse or similar device
RS-232C/422: 1 channel
Ethernet 100BASE-TX/10BASE-T
Use Ethernet port.
Transmission speed: 100Mbps (100BASE-TX)
17 inputs (RESET, STEP0/ENCTRIG_Z0, STEP1/ENCTRIG_Z1, DSA0 to 1,
ENCTRIG_A0 to 1, ENCTRIG_B0 to 1, DI0 to 7)
29 outputs (RUN/BUSY1, BUSY0, GATE0 to 1, OR0 to 1, READY0 to 1, ERROR,
STGOUT0 to 3, DO0 to 15)
- Only camera 4ch type : STGOUT2 and 3.
LCD integrated type: Integrated Controller and 12.1 inch TFT color LCD
(Resolusion: XGA 1024×768)
BOX type: Analog RGB video output 1 channel (Resolusion: XGA 1024×768)
4 channels (supports USB1.1 and 2.0)
24 V DC (20.4 to 26.4 V DC)
Consumption of current varies depending on the type of camera connected.
When FZ-S_/FZ-S_2M/FZ-S_5M_/FZ-SP_/FZ-SF_/FZ-SH_ is connected:
Camera 2ch type : Approx. 3.7A max / Camera 4ch type : Approx. 4.9A
When FZ-SQ____ is connected :
Camera 2ch type : Approx. 5.0A / Camera 4ch type : Approx.7.5A
Between the group of external DC terminals and the ground terminal: 20M Ω min.
(DC100V megger, with internal surge absober removed)
Between the group of external DC terminals and the ground terminal: 1,000 VAC,
50/60 Hz
10 mA max.
1 kV, pulse rise: 5 ns Pulse width: 50 ns
Burst continuing time: 15 ms Cycle: 300 ms
10 to 150 Hz, one-side amplitude 0.1 mm (Max. acceleration 15m/s
10 times for 8 minutes for each three direction
150 m/s ; 3 times each in 6 directions
2
Operating: 0 to +50 °C (with no icing or condensation)
Ambient temperature specifiable. The cooling fan speed can be
switched according to the setting.
0 to +45 °C: Low speed, 0 to +50 °C: High speed
Storage: –20 to +65 °C (with no icing or condensation)
Operating and storage: 35 % to 85 % (no condensation)
No corrosive gases
D-type ground (ground resistance 100 Ω or less) * conventional class 3 ground
IEC60529 IP20
Indoor use
Maximum altitude of 2,000 m
Supply voltage fluctuations of +10 %, –15 % of the rated voltage
Installation category I
Pollution degree 2
ABS
LCD integrated type: Approx. 3.4 kg Box type: Approx. 1.9 kg
)
2