Omron SYSMAC FH Series User Manual page 140

2 Methods for Connecting and Communicating with External Devices
Cause and
correction
Additional
information
Precautions/
Remarks
Event name
Description
Source
Error attrib-
utes
Effects
LED
System-de-
fined varia-
bles
Cause and
correction
Additional
information
Precautions/
Remarks
2 - 78
Occurrence factor (As-
sumed cause)
A Camera is not connected to
the Controller.
The Camera cable is broken.
The Camera Selection set-
tings are incorrect in the
Camera Image Input and
Camera Switching processing
units.
A Camera is not connected to
the Camera port on the Con-
troller according to the The
Camera Selection settings in
the Camera Image Input and
Camera Switching processing
units.
None
None
System error
An error occurred in the system.
EtherCAT Master Function
Module
Level Minor Fault
User pro-
Continuous
gram
EtherCAT NET RUN
-
Variable name
None
Occurrence factor (As-
sumed cause)
A serious error occurred in the
system in the Controller.
None
None
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
Correction
Turn the power supply OFF,
correctly connect a Camera to
the Controller, and turn the
power supply ON.
Turn the power supply OFF,
replace the Camera cable
with a new one, then turn it
back ON.
Properly perform the settings
according to the connected
Camera.
Turn the power supply OFF,
connect the Camera to the
proper Camera port, and then
turn it back ON.
Event code
Source de-
Slave
tails
Error reset
(after reset-
Recovery
ting the error
in the slave)
All functions in slaves stop, and measurement
Operation trigger signals and commands are not accept-
ed.
EtherCAT NET ERR
-
Data type
-
Correction
Consult your OMRON repre-
sentative.
Prevention
Correctly connect a Camera
to the Controller and tighten
the screws.
Use a bending resistant cable
or apply other measures so
that the Camera cable will not
be broken.
Properly configure the set-
tings according to the con-
nected Camera.
Connect the Camera to the
proper Camera port.
4802 0000 Hex
Detection Always at
timing startup
Log catego-
System
ry
EtherCAT LINK/ACT
-
Name
-
Prevention
Consult your OMRON repre-
sentative.