A-1-3 Command List; Command List - Omron SYSMAC FH Series User Manual

A-1-3

Command List

This section lists the commands that you can use with the FH or FHV series and the communications
protocols for which each command is supported.
Additional Information
In addition to the standard communication commands that are given here, you can also create
custom commands and define the processing for them.
Creating custom commands is useful to expand the function of a standard command to create
more advanced commands, and to otherwise combine multiple commands into one command
to simplify controlling operation from a PLC or other external device.
Refer to Custom Communications Commands in the Vision System FH/FHV Series User's
Manual (Cat. No. Z365).
l Execution Commands
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Function
Performs measurement
one time.
Performs continuous
measurement.
Ends continuous meas-
urements.
Performs test measure-
ment for the specified
unit.
Clears all measurement
result values.
Clears the data output
buffer.
Saves the current system
data and scene group
data in the Sensor Con-
troller.
Registers the model
again.
Shifts the image display
position by the specified
amount.
Zooms the image display
in or out by the specified
factor.
FH/FHV Series Vision System User's manual for Communication Settings (Z342-E1)
Parallel PLC link
EtherNet/IP
Ref.: Ref.:
page page
page 2 - 242
2 - 394 2 - 177
*1 OK
NA
OK OK
NA OK
NA OK
OK OK
NA NA
NA OK
NA OK
NA OK
NA OK
EtherCAT PROFINET
Ref.:
Ref.:
page
2 - 52 2 - 303
*1 OK
NA
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
OK OK
Appendices
A
Non-pro-
cedure
Ref.:
Ref.:
page
page
2 - 345
*1 OK
NA
OK OK
OK OK
OK OK
OK OK
OK NA
OK OK
OK OK
OK OK
OK OK
A - 7