Inputs And Outputs - GAL GALaxy eHydro Manual

Section 5 – LCD Interface
GALaxy eHydro Elevator Controller

5.2.5 Inputs and Outputs

The Input and Output menus show the status of all inputs and outputs for the MAIN CPU, the GROUP,
the NTS processor and the Safety PAL. The status of the I/O is shown as a closed diamond " " for ON
and an open diamond " " for OFF. A description every input and output used on the controller and the
board it is located on is shown in the Troubleshooting section. The controller determines which boards
are used depending on the options selected and the number of front and rear floors. All I/O locations
are determined from an io.dat file on the SD Card. I/O's on lines 0-13 and 138-146 of the io.dat file are
placed at hardware dependent locations and their table location should never be changed.
Figure 5-14:
5-17