GAL GALaxy eHydro Manual page 168

GALaxy eHydro Elevator Controller
STATUSF2: Control Status Flag (Status bit set to "1" when status active)
Bit 0: (sfHWI) Hardware Init fault
Bit 1: (sfFDC) Front Door Closing Fault
Bit 2: (sfRDC) Rear Door Closing Fault
Bit 3: (sfLVF) Line Voltage Fault
Bit 4: (sfDVF) Door Voltage Fault
Bit 5:
Bit 6: (sfDMO) Door motor overload
Bit 7: (sfHWL) Learn Hoistway Fault
Bit 8:
Bit 9:
Bit 10:
Bit 11: (sfAFS) At Floor Shutdown
Bit 12:
Bit 13: (sfRSR) Reset run fault
Bit 14:
Bit 15: (sfCOP) COP can comm error
STATUSF3: Control Status Flag (Status bit set to "1" when status active)
Bit 0:
Bit 1:
Bit 2:
Bit 3: (sfASC) APS Selector CAN Fault
Bit 4: (sfNAC) NTS APS Selector CAN Fault
Bit 5: (sfMSP) MC/SPD I/O Fault
Bit 6: (sfSSA) Stop Switch Anti-Creep Releveling
Bit 7:
Bit 8:
Bit 9:
Bit 10:
Bit 11:
Bit 12:
Bit 13:
Bit 14:
Bit 15:
Section 6 – Main CPU Faults & Detailed Faults
Bit 16:
Bit 17: (sfIOT) IO Test in progress
Bit 18:
Bit 19:
Bit 20: (sfNIT) Non-Interference timer
Bit 21: (sfDRQ) Door open request
Bit 22: (sfDPM) Waiting for DPM
Bit 23: (sfRPM) Waiting for RPM
Bit 24: (sfVSC) Viscosity operation
Bit 25: (sfLVR) Leveling request
Bit 26:
Bit 27:
Bit 28: (sfEES) Front EE Test failed fault
Bit 29: (sfERS) Rear EE Test failed fault
Bit 30:
Bit 31:
Bit 16:
Bit 17:
Bit 18:
Bit 19:
Bit 20:
Bit 21:
Bit 22:
Bit 23:
Bit 24:
Bit 25:
Bit 26:
Bit 27:
Bit 28:
Bit 29:
Bit 30:
Bit 31:
6-104