GAL GALaxy eHydro Manual page 205

GALaxy eHydro Elevator Controller
Table 7-4: Service Options
Field Variable Min
Sec ReasignCC 0
Sec Recall 2 0
Security Flr 0
Security Rcl 0
SR CCSec Dir 0
Max Initial Units
3 0 -
2 0 -
Top
1 floor
Floor
15 0 -
2 0 -
Section 7 – Main CPU Adjustable Variables
Security Reassign Car Call. Re-assign secured car call
to opposite door. Used with security configuration
cons.dat file setting: cons[SecFlCfg] = 2.
0 = Disabled,
+1 = In case front CC are secured, reassign them as
rear,
+2 = In case rear CC are secured, reassign them as
front.
Security Recall Control 2.
0 = Out of group on first recall.
1 = Out of group on all recalls.
2 = No out of group recalls.
Security Floor. The security recall floor. This is the
floor where the security guard would be stationed.
This floor would not be locked out when on security.
Security Recall Selection.
0 = No: No Recall,
+1 = Recall to Security Floor on activation of security.
+2 = Cycle front door once recalled to the Security
Floor.
+4 = Cycle rear door once recalled to the Security
Floor.
+8 = Always recall to security floor after each run.
Second Riser Car Call Security by Direction. Allows
calls in the one direction but disables them in the
other.
1 = Allow calls in the up direction (above the floor)
but disable them going down,
2 = Allow calls in the down direction (below the floor)
but disable then going up.
7-20