Setting Hoistway Floor Levels With Aps Selector - GAL GALaxy eHydro Manual

GALaxy eHydro Elevator Controller
2.7.2.4

Setting Hoistway Floor Levels with APS Selector

•
Put the elevator on car top inspection.
Temporarily set the car door bypass switch to the BYPASS position. Setting the car door
bypass switch to the BYPASS position will allow the car to be moved on car top
inspection with the car door open. All safety precautions must be followed to ensure the
safety of elevator personnel and the general public when moving the car on car top
inspection with the car door bypass switch in the BYPASS position.
• Move the jumper on the GALX-1134AN COP board to the setup position. See Figure 2-19.
Figure 2-19: GALX-1134AN COP Interface Board Setup Jumper
Section 2 –Installation
Run/Setup
Jumper
2-16