GAL GALaxy eHydro Manual page 28

GALaxy eHydro Elevator Controller
Figure 2-9: Lower Bracket with Springs Properly Compressed to the Marks
Step 4: Install the selector mounting bracket.
•
Mount the selector mounting bracket to the cross head.
•
Use the roller or slide shoe guide bolts to hold the camera bracket. The face of the bracket
should be about 5 ½ inches from the back of the rail. See Figures 2-10 and 2-11.
•
The back of the bracket should be as close as possible to the crosshead channel.
•
Use a level and make sure it is plumb and level.
Figure 2-10: APS Camera and Mounting Bracket
Section 2 –Installation
2-10