GAL GALaxy eHydro Manual page 26

GALaxy eHydro Elevator Controller
Figure 2-4: Unroll the Encoded Tape
Figure 2-5: Guide Clip with
Door Zone Bridge
Step 3: Install the bottom selector bracket and attach the encoded tape.
•
Mount the bottom selector bracket onto the car guide rail as shown in Figure 2-7.
•
Make sure the bracket is low enough that, when the car fully compresses car buffer, that the
encoded tape is still within the field of view of the APS cameras, and that nothing on the car
contacts the bracket.
•
Attach the encoded tape to the rail bracket with the slack tape switch.
•
Make sure to feed the tape through the front side of the bracket (the side facing the car) first, and
then bend it back up toward the back of the tape. See Figure 2-8.
•
Push the bracket down until the springs are depressed to the mark in order to properly tension
the encoded tape. See Figure 2-9.
•
The slack tape switch should be properly installed and wired according to the wiring schematics
and connection diagrams
Section 2 –Installation
Figure 2-6: Guide Clip without
Door Zone Bridge
2-8