GAL GALaxy eHydro Manual page 24

GALaxy eHydro Elevator Controller
To install the APS Selector, follow steps 1 through 8 below:
Step 1: Install top selector bracket and attach the encoded tape.
•
Mount the top J-hook selector bracket to the rail.
•
Make sure the bracket is high enough that, when the car is on the stop ring above the top
terminal landing, that the encoded tape is still within the field of view of the APS cameras, and
that nothing on the car contacts the bracket.
•
Attach the encoded tape to the top bracket keeping the encoded tape as close to the rail as
possible. See Figure 2-1.
•
Make sure to feed the tape through the front side of the bracket first (the side facing the car), and
then bend it around the top of the bracket and lace it back down. Make sure that the encoded
side of the tape faces the car and that the "LEFT" markings on the tape are on the left side. See
Figures 2-2 and 2-3.
•
Fasten the tape with the supplied bracket and screws.
Figure 2-1: Encoded Tape Mounting – Top Bracket
Section 2 –Installation
2-6