Enabling Redisplaying Entered-But-Not-Submitted Commands; Understanding Command-Line Error Messages - HP 10500 Series Configuration Manual

Hotkey
Esc+F
Esc+N
Esc+P
Esc+<
Esc+>

Enabling redisplaying entered-but-not-submitted commands

Your input might be interrupted by system information output. If redisplaying entered-but-not-submitted
commands is enabled, the system redisplays your input after finishing the output. You can then continue
entering the command line.
To enable redisplaying entered-but-not-submitted commands:
Step
1. Enter system view.
2. Enable redisplaying
entered-but-not-submit
ted commands.

Understanding command-line error messages

After you press Enter to submit a command, the command line interpreter examines the command syntax.
If the command passes syntax check, the CLI executes the command.
•
• If the command fails syntax check, the CLI displays an error message.
Table 3 Common command-line error messages
Error message
% Unrecognized command found at '^' position.
% Incomplete command found at '^' position.
% Ambiguous command found at '^' position.
% Too many parameters.
% Wrong parameter found at '^' position.
Function
Moves the cursor forward one word.
Moves the cursor down one line. This hotkey is available before you press Enter.
Moves the cursor up one line. This hotkey is available before you press Enter.
Moves the cursor to the beginning of the clipboard.
Moves the cursor to the ending of the clipboard.
Command
system-view
info-center synchronous
7
Remarks
N/A
By default, the system does not redisplay
entered-but-not-submitted commands.
For more information about this command, see
Network Management and Monitoring
Command Reference.
Cause
The keyword in the marked position is invalid.
One or more required keywords or arguments are
missing.
The entered character sequence matches more than one
command.
The entered character sequence contains excessive
keywords or arguments.
The argument in the marked position is invalid.