Table of Contents
Advertisement
1000 HOURS LUBRICATION AND MAINTENANCE CHECKS
Maintenance for every 10, 250, & 500 hour Lubrication and Maintenance Checks should also be performed at this
time.
NOTE: "Lube Key" references are to the lubrication chart.
Truck Serial Number______________________
Hourmeter_____________
1.
HYDRAULIC TANK - Drain the hydraulic tank and
clean the inlet strainer. Refill the tank with new oil;
approximate capacity 901 l (238 gal). Use Lube Key
B.
NOTE: Oil change interval can be extended to 2,500
hours if oil is sampled at every 250 hour intervals and
no abnormalities are detected.
2.
RADIATOR - Clean the cooling system with a quality
cleaning compound. Flush with water. Refill the sys-
tem with anti-freeze and water solution. Check the
Cooling System Recommendation Chart in this sec-
tion for the correct mixture. Refer to the engine manu-
facturer's Operation and Maintenance Manual for the
correct additive mixture.
3.
FUEL TANK - Remove the breather and clean in sol-
vent. Dry with pressurized air and reinstall.
4.
OPERATOR'S SEAT - Apply grease to the slide rails.
Lube Key D.
5.
AUTOMATIC BRAKE APPLICATION - Ensure the
brakes are automatically applied when brake pres-
sure decreases below the specified limit. Refer to the
appropriate Shop Manual, Section J, Brake Check-
out Procedure.
6.
FRONT ENGINE MOUNT TRUNION - Add one or
two applications of grease at fitting. Lube key "D".
7.
AUTOMATIC LUBE SYSTEM PUMP - Check pump
housing oil level. Refill to bottom of level plug with
SAE 10W-30 motor oil.
8.
ELIMINATOR FILTER - Clean and check centrifuge.
Refer to engine manufacture's Operation & Mainte-
nance Manual. (Service interval is dependent on duty
cycle, oil quality, etc.)
P2-16
Site Unit Number_______________
Name of Service Technician___________________________________
TASK
Lubrication and Service
Date_______________
COMMENTS
CHECKED INITIALS
10/06 P02050
Advertisement
Chapters
Table of Contents
