Advertisement
4.4
Connecting the Emulator
Select either of the following two ways to connect the emulator:
(a) Connecting the emulator after the setting at emulator activation
Select [Debug settings] from the [Debug] menu to open the [Debug Settings] dialog box. It is
possible to register the download module or the command chain that is automatically executed
at activation. For details on the [Debug Settings] dialog box, refer to section 4.2, Setting at
Emulator Activation.
After the [Debug Settings] dialog box has been set, when the dialog box is closed, the emulator
is connected.
(b) Connecting the emulator without the setting at emulator activation
The emulator can be easily connected by switching the session file that the setting for the
emulator use has been registered.
Figure 4.21 Selecting the Session File
Section 4 Preparations for Debugging
Rev. 1.00 Nov. 26, 2007 Page 75 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
