Advertisement
Note: Along with setting the address range, the start and end of the address range can be set in
the [From] and [To] options, respectively.
(3) [Data] page
Set a data condition.
[Don't care]:
Detects no data when this box is checked.
[Setting]:
Detects the specified data.
[Point]: Specifies single data (not available when [Don't care] has been checked).
[Range]: Specifies a data range (not available when [Don't care] has been checked).
[From]: Enter single data or the minimum value of the data range (not available when
[Don't care] has been checked).
[To]:
Enter the maximum value of the data range (only available when [Range] has
been selected).
Note: Along with setting the data range, the minimum and maximum values can be set in the
[From] and [To] options, respectively.
Figure 5.31 [Trace Filter] Dialog Box ([Data] Page)
Section 5 Debugging
Rev. 1.00 Nov. 26, 2007 Page 135 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
