Advertisement
• Set the same program counter and stack pointer values (PC = H'00000800 and R15 =
H'FFF90000) as were set in section 6.8, Setting Registers (again, use the [Register] windows
in the High-performance Embedded Workshops for CPU0 and CPU1). After that, click on the
[Go] buttons in the High-performance Embedded Workshops for CPU0 and CPU1.
The internal RAM area differs according to the MCU. Refer to the hardware manual for the
MCU in use.
• If program execution is failed, reset the device and execute again the procedures above.
• After the break in program execution, select [Stack Trace] from the [Code] submenu of the
[View] menu to open the [Stack Trace] window.
Figure 6.49 shows that the position of the program counter is currently at the selected line of the
sort() function, and that the sort() function is called from the main() function.
To remove the hardware break, double-click the [Event] column in the sort function again.
Note: For details on this function, refer to the online help.
Figure 6.49 [Stack Trace] Window
Rev. 1.00 Nov. 26, 2007 Page 197 of 230
Section 6 Tutorial
REJ10J1766-0100
Advertisement
Troubleshooting
