Advertisement
Section 5 Debugging
[Start PTR]:
[End PTR]:
Note: Along with setting the range for filtering, PTR values to start and end filtering can be set
in the [Start PTR] and [End PTR] options, respectively.
(2) [Address] page
Set an address condition.
Figure 5.30 [Trace Filter] Dialog Box ([Address] Page)
[Don't care]:
Detects no address when this box is checked.
[Setting]:
Detects the specified address.
[Point]: Specifies a single address (not available when [Don't care] has been checked).
[Range]: Specifies an address range (not available when [Don't care] has been checked).
[From]: Enter a single address or the start of the address range (not available when
[Don't care] has been checked).
[To]:
Enter a single address or the end of the address range (only available when
[Range] has been selected).
Rev. 1.00 Nov. 26, 2007 Page 134 of 230
REJ10J1766-0100
Enters a PTR value to start filtering.
Enters a PTR value to end filtering.
Advertisement
Troubleshooting
