Advertisement
Section 6 Tutorial
• To change the value of the program counter (PC), double-click the value area in the [Register]
window with the mouse. The following dialog box is then displayed, and the value can be
changed. Set the program counter to H'00000800 in this tutorial program, and click the [OK]
button.
• Change the value of the stack pointer (SP) in the same way. Set H'FFF90000 for the value of
the stack pointer in this tutorial program.
When using the MCU with flash memory, specify the end address of the internal RAM for the
stack pointer (SP). The internal RAM area differs depending on the MCU. Refer to the
hardware manual of the MCU used.
Rev. 1.00 Nov. 26, 2007 Page 158 of 230
REJ10J1766-0100
Figure 6.8 [Register] Dialog Box (PC)
Figure 6.9 [Register] Dialog Box (R15)
Advertisement
Troubleshooting
