3.9
Setting up the Emulator
Set up the emulator's firmware using the following procedures. The emulator will be set up for the
first device group to be started.
Note: Only one device group can be set up after the initial purchase of the emulator
emulator for another device group after set up, purchase the license tool to add a device
group.
Do not disconnect the USB cable unless instructed to do
so by an on-screen message. Incorrect operation will damage
the emulator product.
CAUTION
Section 3 Preparation before Use
Rev. 1.00 Nov. 26, 2007 Page 37 of 230
REJ10J1766-0100
To use the
.