Advertisement
Section 4 Preparations for Debugging
2. If an incorrect driver has been selected, the following dialog box will appear.
Figure 3.36 [Unable to restore the previous driver settings] Dialog Box
3. If the emulator is not activated due to other reasons, a message box corresponding to
the status is displayed. Use the message as a reference to check the wiring on the
board.
3.11
Uninstalling the Emulator's Software
Follow this procedure to remove the installed emulator's software from the user's host computer.
As the installed product is registered with the High-performance Embedded Workshop, uninstall
the product on the High-performance Embedded Workshop screen.
It is also possible to uninstall the emulator's software by using [Add/Remove Programs] in the
control panel. In this case, however, note that all the tools (including the compiler) in the High-
performance Embedded Workshop will be removed.
1.
Activate the High-performance Embedded Workshop.
2.
Click the [Administration...] button in the [Welcome!] dialog box.
Rev. 1.00 Nov. 26, 2007 Page 50 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
