Advertisement
Section 5 Debugging
Items that can be displayed in the sheet are listed below.
[Loading flash memory]
[Erasing flash memory]
[File name]
[Bus width of flash memory]
[Flash memory erasing time]
[Entry point]
Rev. 1.00 Nov. 26, 2007 Page 86 of 230
REJ10J1766-0100
Sets Enable for flash memory downloading. At Enable, when
the flash memory is downloaded on the High-performance
Embedded Workshop, the write module is always called.
Disable: Not download to the flash memory
Enable: Download to the flash memory
Sets Enable for erasing before the flash memory is
programmed. At Enable, the erase module is called before
calling the write module.
Disable: Not erase the flash memory
Enable: Erase the flash memory
Sets the write/erase module name. The file that has been set is
loaded to the RAM area before loading to the flash memory.
Sets the bus width of the flash memory.
Sets the TIMEOUT value at flash memory erasing. Increase
the value if erasing requires much time although the default
time is three minutes. The values that can be set are as follows:
D'0 (minimum) and D'65535 (maximum). Only positive
integers can be input.
Sets the calling destination address or access size of the
write/erase module. (It must be RAM address.)
All erasing module address: Inputs the calling destination
Writing module address:
Access size:
address of the erase module.
Inputs the calling destination
address of the write module.
Selects the access size of the RAM
area that is used for loading the
write/erase module.
Advertisement
Troubleshooting
