Advertisement
[Mode]
[Emulation mode]
[Step option]
[Read/Write on the fly]
[AUD clock]
[JTAG clock]
Displays the MPU name.
Selects the emulation mode at user program execution.
Select Normal to perform normal emulation.
Select No break to disable PC breakpoint or break condition
settings during emulation.
Sets the step interrupt option.
Disable interrupts during single step execution: Disables
*1
interrupts
during step execution.
Enable interrupts during single step execution: Enables
interrupts during step execution.
Sets the mode of memory access during execution of the user
program (this does not affect access to memory by the user
program).
Disable: Memory access is not possible during execution of the
user program.
H-UDI Read/Write: Execute the memory access by using the
H_UDI.
Short Break Read/Write: Access to memory is during short
breaks in execution of the user program. This suspends
execution of the user program for longer periods than access
via the H-UDI.
A clock used in acquiring AUD traces. If its frequency is set
too low, complete data may not be acquired during realtime
tracing. Set the frequency not to exceed the upper limit for the
MPU's AUD clock. The AUD clock is only needed for using
emulators that have an AUD trace function. For the upper limit
for the AUD clock, refer to section 2.2.3, Notes on Using the
JTAG (H-UDI) Clock (TCK) and AUD Clock (AUDCK), in
the additional document, Supplementary Information on Using
the SHxxxx.
A communication clock used except for acquiring AUD trace.
If its frequency is set too low, the speed of downloading will
be lowered. Set the frequency not to exceed the upper limit for
the MPU's guaranteed TCK range. For the upper limit for
TCK, refer to section 2.2.3, Notes on Using the JTAG (H-UDI)
Clock (TCK) and AUD Clock (AUDCK), in the additional
document, Supplementary Information on Using the SHxxxx.
Section 5 Debugging
Rev. 1.00 Nov. 26, 2007 Page 81 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
