Advertisement
Table 6.3 shows the options for the [Loading flash memory] page.
Table 6.3 [Loading flash memory] Page Options
Option
[Loading flash memory]
radio button
[Erasing flash memory]
radio button
[File name] edit box
[Bus width of flash
memory] list box
[Flash memory erasing
time] edit box*
[Entry point] group box
Note: Although the values that can be set are D'1 to D'65535, the TIMEOUT period may be
extended according to the set value. Therefore, it is recommended to input the minimum
value by considering the erasing time of the flash memory in use.
Description
Sets Enable for flash memory downloading.
When Enable is selected, and [File load] is selected from the [File]
menu for downloading, the write module is always called.
Enable: Download to the flash memory
Disable: Not download to the flash memory
Sets Enable for erasing before the flash memory is programmed.
When Enable is selected, the erase module is called before calling the
write module.
Enable: Erase the flash memory
Disable: Not erase the flash memory
Sets the file name of the S-type load module including the write and
erase modules. The file that has been set is loaded to the RAM area
before loading to the flash memory.
A maximum of 128 characters can be input for the file name.
Sets the bus width of the flash memory.
Sets the TIMEOUT value for erasing the flash memory. Set a larger
value if erasing requires much time; the default time is three minutes.
The radix for the input value is decimal. It becomes hexadecimal by
adding H'.
Sets the calling destination address or access size of the write and
erase modules.
[All erasing module address] edit box: Inputs the calling destination
address of the erase module.
[Writing module address] edit box: Inputs the calling destination
address of the write module.
[Access size] combo box: Selects the access size of the RAM area
where the write/erase module is loaded.
Rev. 1.00 Nov. 26, 2007 Page 203 of 230
Section 6 Tutorial
REJ10J1766-0100
Advertisement
Troubleshooting
