6.16
Forced Breaking of Program Executions
The High-performance Embedded Workshop can force a break in the execution of a program.
• Cancel all breaks.
• To execute the remaining sections of the main function, select [Go] from the [Debug] menu in
the High-performance Embedded Workshop for CPU1, or the [Go] button on the toolbar. After
that, select [Go] from the [Debug] menu of the High-performance Embedded Workshop for
CPU0, or click on the [Go] button on the toolbar.
• The program goes into an endless loop. To force a break in execution, select [Halt] from the
[Debug] menu of the High-performance Embedded Workshop for CPU1, or click on the
[STOP] button on the toolbar. Since the [Break] check box under [Synchronization options] of
the High-performance Embedded Workshop for CPU0 is enabled, the High-performance
Embedded Workshop for CPU0 will be halted at the same time as that for CPU1.
Figure 6.29 [Go] Button
Figure 6.30 [STOP] Button
Rev. 1.00 Nov. 26, 2007 Page 175 of 230
Section 6 Tutorial
REJ10J1766-0100