Advertisement
Section 5 Debugging
5.5.20
Sequential Conditions
Sets the sequential condition of the break channel.
5.5.21
Editing Break Conditions
Handlings for settings other than PC breakpoints and break conditions are common. The following
describes examples of such handling.
5.5.22 Modifying Break Conditions
Select a break condition to be modified, and choose [Edit...] from the popup menu to open the
dialog box for the event, which allows the user to modify the break conditions. The [Edit...] menu
is only available when one break condition is selected.
5.5.23
Enabling Break Conditions
Select a break condition and choose [Enable] from the popup menu to enable the selected break
condition.
5.5.24
Disabling Break Conditions
Select a break condition and choose [Disable] from the popup menu to disable the selected break
condition. When a break condition is disabled, the break condition will remain in the list, but an
event will not occur when the specified conditions have been satisfied.
5.5.25 Deleting Break Conditions
Select a break condition and choose [Delete] from the popup menu to remove the selected break
condition. To retain the break condition but not have it cause an event when its conditions are met,
use the [Disable] option (see section 5.5.24, Disabling Break Conditions).
5.5.26 Deleting All Break Conditions
Choose [Delete All] from the popup menu to remove all break conditions.
Rev. 1.00 Nov. 26, 2007 Page 106 of 230
REJ10J1766-0100
Advertisement
Troubleshooting
